Brilliance Organics

SOFT SOIL APPLICATIONS: INSTALLING THE GROUND STAKE & FIXTURE 

1. Connect the power cable from the fixture body to the landscape cable.

2. Lay the power cable into the slotted relief on the stake.

3. Press the fixture and stake into the ground.

4. Use a level to ensure the top of the stake is level with the ground.

HARD SOIL APPLICATIONS: INSTALLING THE GROUND STAKE & FIXTURE 

1. Unscrew the fixture body from the stake.

2. Dig a hole approximately 4” wide by 10” deep and gently tap the stake into the ground with a rubber mallet.

3. Use a level to ensure the top of the stake is level with the ground.

4. Reinstall the fixture body onto the stake and lay the power cable into the slotted relief on the stake.

5. Connect the power cable from the fixture body to the landscape cable.

ADJUSTING THE FIXTURE 

1. Turn the thumbnut counter-clockwise to loosen the knuckle.

2. Rotate the fixture vertically to the preferred position.

3. Turn the thumbnut clockwise to hold it in the preferred position. Adjusting the fixture allows for dark sky ordinance applications.

REPLACING THE LAMP 

1. Hold the fixture base in one hand and press a finger against the bottom of the cap until it slightly pops up.

2. Use the other hand to grasp around the top shield and pull it off.

3. Install the lamp into the socket with the tension spring behind the body of the lamp.

4. Compress the tension spring into the body and reinstall the top cap over the fixture body. The cap should snap over both o-rings on the body fixture.

IMPORTANT: Replace the o-rings if necessary.