Description
The top of the Black Diamond PAR36 fixture is available in Black Brass and Bronze finishes and the body is made of composite material.
To clean the fixture, periodically wipe it down with a mild soap and water.
INSTALLING THE LAMP
Loosen the thumbscrew on the lens cap and remove the lens cap and the stainless steel gimbal from inside the Black Diamond PAR36 Well Light.
Install the lamp and snap it into the gimbal.
Return the gimbal to the well light.
Place the lens cap and tighten the thumbscrew to protect from debris.
INSTALLING THE FIXTURE
Dig a hole in the ground approximately 12” wide by 14” deep.
Connect the power cable to the fixture, leaving 2 feet of wire coiled in the bottom of the fixture for future service.
Pour 8” of pea gravel in the hole.
Place the fixture in the center of the hole.
Add more pea gravel to fill the hole 1” before the fixture lip. This allows for proper drainage around the fixture.
Place the specified lens assembly on the top of the fixture and tighten the set screw. Use the specified lens in all applications to protect from debris.
Apply glass wax on top of the lens to protect against standing water.
Reviews
There are no reviews yet.